Browse all Albany County, NY

Landfill Gas Blower Skid Parts, Preventative Maintenance and Repair

The work includes: Alteration of interior of building to include removal and interior alterations to 1,750 s.f. of existing building with general construction, plumbing, and electrical work.

This project is to consolidate the Staten Island Family Court program and create a Reconfigured Family Court by constructing an 8-story new addition at 10 Hamilton Ave., a full renovation of the existing historic Court building at 100 Richmond, and a full renovation of the adjacent unoccupied building at 55 Stuyvesant, including the forecourt and courtyard spaces. The entire Campus will encompass approximately 169,000 GSF

Painting Services

The Dormitory Authority State of New York (DASNY) is seeking proposals from firms to provide materials testing and special inspection services on various DASNY projects throughout New York State as required per Chapter 17 of the governing project Building Code. Working together with DASNYs Office of Code Compliance, consultants will provide services that may include but is not limited to testing and inspection of any or all of the following construction specialties: Concrete (cast in place and precast), Structural Steel, Soils, Deep Foundations, Underpinning, Masonry, Spray Fire Restive Materials, Firestopping, Window Testing, Roofing, Curtain Walls, EIFS, Pipe Welding, Non-Destructive Testing, Mechanical and Energy Code Compliance Inspections, Progress Inspections, and Quality Assurance Inspections where applicable

DASNY seeks proposals from qualified firms to perform construction site safety services. The objective of this procurement is to establish term contracts with consultants to provide required services for multiple assignments, with a wide range of clients and facilities, for projects that vary in size, scope, and complexity. Firms responding to this RFP shall meet the qualifications listed below: Consultant representatives must have a minimum of ten (10) years loss control and safety consulting experience specific to site safety Consultant representatives must have a strong knowledge of OSHA, NYC Department of Buildings, and industry construction safety standards Consultant must, on an as-needed basis, be able to provide the services of technical specialists (ACGIH-certified industrial hygienists, ergonomists, and other specialized consultants) and provide consulting and technical services to address hazards, project conditions, and questions related to same. Consultants must be able to provide electronic survey reports within three (3) business days of the site visit. Consultant must be able to track and sort survey results in order to provide periodic trending reports to upper management and DASNYs clients. Consultant must have access to software and other supplies required to produce training materials, including booklets and other presentation materials

Field and Support Services Field support services include, but are not limited to, preventative maintenance per O&M and best practices, cleaning, repair, diagnostics and troubleshooting, installation, startup, calibration and verification. Field support services shall include motor and pump support as well as PLC and SCADA integration services when it is anticipated the scope will require them. General Services Startup and Equipment Training as requested Emergency telephone support within 2 Hours Emergency Support within 24 Hours Onsite Specification and Quotation Development Page 49 Annual VFD & MCC Preventative Maintenance, Repair, and Emergency Support Services JB362 Opening: 05/13/26 11:30 AM SPECIFICATIONS 04 BID-D Annual VFD and MCC JB362 As Posted.docx Last Updated:4/14/2026 12:35 PM Product Recommendation Existing Equipment The Town has identified the need for a VFD and MCC service contractor to provide support services for the following equipment. The Successful Bidder shall be capable of preventative maintenance, cleaning, replacement component installations, diagnostics and troubleshooting, startup and calibration services, programming and other support services involving, but not limited to the following types of equipment with general locations noted: Latham Water Equipment

2026 Installation of Pre-Fabricated Restroom at The West Albany Memorial Park DB359

Actual work may vary dependent upon district needs and/or NYS code requirements. The Contractor will be required to submit an estimate of repairs (labor and materials) prior to obtaining district approval for the actual performance of service

Hardwood Floor Refinishing

Occasional Electrical Repair

Waste Removal and Recycling

Septic System Maintenance includes pumpin of septic grease, etc from various locations.

The intent of these specifications is to furnish information to responsible bidders for the purpose of obtaining bids for the rehabilitation of twin elliptical aluminum pipes conveying Fox Creek, located at 1007 County Route 352, Town of Rensselaerville, NY 12147, Pipe Lining Project, as requested by Albany County Department of Public Works

Garage Dock Leveler Replacement

Fire Sprinklers Testing & Inspection

Memorial Town Hall Brick Paver Installation

Furnish and install specified roof restoration coating and related components on the following roof area(s) as found on the Community Room Roof Area; Roof Area(s); A thru G Roof Area(s); Connecting Link to Main Building

236220 - Commercial and Institutional Building Construction. The New York District (NAN) of the U.S. Army Corps of Engineers (USACE) proposes to perform Installation of a switching station capable of feeding 4000 kW of power into the existing south switch station. his project will consist of constructing an electrical switching station to provide backup power in the event of a long-term power outage from the facility Main Substation. The scope entails the procurement and installation of four (4) 2MW generators, construction of a facility for the generators, installation of electric manholes, duct bank, grounding cable, fencing, switchgear, transfer switches, cables, splices and connections, paving, walks, curbs, gutters, and utilities testing and commissioning. Additionally, all necessary utility interconnections to bring fuel to the power generation facility and connecting the new switching station to the existing.

This project is to design, fabricate and install a 5.0 ft (high) by 15 ft (wide) hydraulic lift door to be fitted atop an existing 28ft hangar door to accommodate the taller tail height of an Embraer E175 aircraft